Water data for
your exploration programs.
Waterloop meters the water your drill programs take, from the lake pump to the rig and the camp, and gives your team measured volumes for authorizations and annual water reporting.
Book a 30-minute callWater data for
mineral exploration
What an exploration program reports on water
- WithdrawalThe volume taken from each lake, stream or well, within the authorized limit.
- By sourceTotal water withdrawn in the year, split between surface water and groundwater.
- ContractorsThe water your drilling contractors use on each rig, and at camp.
From contractor reports
to measured flow.
On most drill programs, water figures are pieced together after the fact: pump hours on the driller’s daily sheet, a contractor’s estimate, a total assembled for the annual report.
Waterloop puts a meter on the lines that matter and records flow as it happens. Your team sees the volumes while the program runs, and the year-end total adds itself up.
See what it coversA small module.
Every water line in view.
From the lake pump to the rig and the camp,
measured, not estimated.
No meter?
We supply and install one.
Most water lines on a drill program have no meter. We supply and install one, and a battery-powered module sends its readings. Where a meter is already in place, the module reads it.
- We supply the meter
- Meter and module, installed on the line with your team and the drill crew.
- Moves with the rig
- Battery-powered, with no wiring to the rig. It goes from pad to pad with the crew.
- Readings, not tallies
- Flow is recorded continuously and sent to the platform, so nobody adds up water by hand.
And every program
adds up on its own.
One dashboard per program: every source, rig and camp line, day by day, with totals for any reporting period.
- React in time
- Alerts by text or email when a rig’s water stops, or when a lake’s daily withdrawal nears its authorized limit.
- Report from the record
- Export volumes per source, rig and contractor, for any period. A PDF for the file, CSV for your consultants.
Water withdrawn, this program
2,628 m³
Surface water 93% · Groundwater 7%
Lake withdrawal today
31.6 m³
Pump P-2 · Lac Doré
060 m³ · authorized limit
Today, by line
- Lac Doré · P-231.6 m³Surface
- Well PW-12.4 m³Ground
- Rig D-0422.9 m³Rig
- Camp9.2 m³Camp
Rig D-07: no water flow since 03:10
Measured volumes behind
your water reporting.
The same water,
reported several ways.
What it asksThe volume taken from each lake, stream or well, kept within the authorized limit.
What Waterloop gives youDaily volumes per source against the limit, and an alert before you reach it.
What it asksTotal water withdrawn in the year, split between surface water and groundwater.
What Waterloop gives youMeasured withdrawal per source, totalled for any reporting period.
What it asksThe water drawn by each contractor on your program, without relying on daily sheets.
What Waterloop gives youVolumes per rig and per contractor, read from the meter.
What it asksDocumented water management and monitoring practices on the exploration site.
What Waterloop gives youA continuous flow record that supports your procedures. Water-quality sampling stays separate.
What it asksMeasured water use on your programs, and improvement over time.
What Waterloop gives youMeasured volumes per program, comparable from one season to the next.
Waterloop supplies the measured record. Regulators, auditors and certifiers decide what it satisfies.
Built for the drill site.
Installed with your contractors.
Remote pads, winter programs and rigs that move every few days. We choose the measuring points with your team and install them with the drill crews.
-
Moves with the rig
Battery-powered, fixed to the water line. Take it off at the end of a hole and refit it on the next pad.
-
Out of coverage
Readings are stored on the module and sent when it is back in range, so a remote pad loses nothing.
-
Every line, one view
Lake pumps, wells, rigs and camp on one program, and several programs side by side.
-
Any reporting period
Totals by source, rig and contractor for the month, the season or the year.
Before your
next program.
The questions exploration teams ask us first.
Does Waterloop make us compliant?
No. Authorizations, audits and certification are decided by regulators, auditors and certifiers. Waterloop gives you the measured record behind the numbers you report.
What if a water line has no meter?
Then we supply and install the meter along with the module. Where a meter or flowmeter is already in place, the module reads most of them as they are.
What do our drilling contractors have to do?
Very little. We install with the crew at mobilization and move the module when the rig changes pads. They no longer tally water by hand.
Our pads have no coverage. Is that a problem?
The module stores its readings and sends them when it is back in range, so no data is lost between connections.
Does it measure water quality?
No. Waterloop measures volumes and flow. Water-quality sampling, including what Directive 019 requires, stays with your environmental program.
Is it available in French?
Yes. The platform, the reports and support are in French and English.